iNew i3000, Android 4.2, quad-core and 5-inch display at $234.99


Straight off the back of the hugely popular iNew i2000 comes the iNew i3000 with 5-inch display, quad-core processor and Android 4.2.

iNew have shot to internet fame for their low-cost Android phones, and have even grabbed the attention of members of the XDA Developers forum (fingers crossed for some awesome custom ROMS).

Gizchina News of the week


The iNew i3000 offers the same great value for money as the larger i2000, but in a more compact (but still far from small) 5-inch form factor. Like many modern phone iNew have managed to keep the size down further by using narrow bezels meaning the phone measures in at 72mm wide.

Under the 5-inch 1280 x 720 display and safely inside the 9.2mm body is a 1.2Ghz, quad-core MT6589 processor, 1GB RAM, dual-sim support, micro SD card reader, Bluetooth, GPS and an 8 mega-pixel rear camera,

You can pick up the iNew i3000 for $234.99 at SpeMall here.

Previous JiaYu G4 Hands on Video
Next ZTE Announce ZTE Grand X2 with Intel Inside

9 Comments

  1. May 15, 2013

    Hi Abbie..on which site this is available to purchase and whether they will ship to India

    • May 15, 2013

      Link in the article 🙂

  2. May 15, 2013

    Do iNew have an official web page where we can be notified of updates for their devices?

  3. Michael Westcott
    May 16, 2013

    Until Chinese manufacturers start respecting the GPL that’s attached to the Linux kernel and start releasing their sources, there will be no decent custom roms like Cyanogen Mod and Paranoid Android for these phones. That’s what sets Oppo apart, they release their kernel source!

  4. simmer
    May 16, 2013

    oppo is not MTK it’s uses snapdragon S4 oppo does not manufacture those chips and their drivers it’s the manufacture which is MTK which does not releases their drivers to public

    • JanM
      May 17, 2013

      +1

      • Michael Westcott
        May 19, 2013

        That’s not entirely correct. Even if MTK did release their source code, you’d still need the manufacture to give you the config files and patches they made before you could compile a kernel to work on their devices and have all the peripheral hardware and sensors work. The manufactures do have the kernel source, they couldn’t make their devices without it.